This product is no longer in stock
Available now for the 2010-2015 Camaro is our 3-1/2 aluminum shaft with CV. We have done extensive testing with stock rears and with our 9.00in kit and believe this to the most cost-effective trouble-free drive shaft for the Camaro available today.
The shaft will come with our signature billet plates for each end so you don’t have to go into the rear taking a chance on upsetting the crush collar (see below for billet plate VS changing to a Pinion yoke below). Our shaft comes with a 300m stub system mounted into a billet aluminum plate to ensure not only strength but lighter weight than the normal way of doing this type of end (look closely at the CV end, it’s not all steel). The shaft only weighs 28lbs and comes with special grade 12.9 uber strength hardware with backup lock nuts to ensure no loose bolts. We have been using this billet aluminum style plate for over 10 years on thousands of 1000+Hp Supras, BMWs and many more without any bolt issues.
You will have to remove the heat shield from above the center hanger mount to install a 3-1/2″ shaft. There is a possibility of clearance issues with aftermarket exhausts. This is a general warning. We have 9 test shafts out and not one had an issue. I have listed this because not all exhaust systems have been tested. (Our Carbon fiber shaft will be made from 3-3/8 and not the 3-3/4 like other manufacturers.)
- May have exhaust clearance issues on the 3.50in shafts
2010-2015 Chevrolet Camaro V8
No customer comments for the moment.